RC Model Overall Width Simulation
Author: WUNExecutions: 5968
※ This library was created by a member. This site is not responsible for its content.
Enter the length (width) of each component, and the total width will be calculated automatically. Please use this for body fitting simulations and other purposes. The total width refers to the distance between the outer surfaces of the wheels.
● Suspension arm length = Distance between the inner pin and the outer pin
● Hub carrier offset = Distance between the hub carrier pin and the outer bearing surface of the hub carrier (3.5 mm for YD-2 standard)
*If it is difficult to measure the hub carrier scrub amount, with the hub carrier mounted on the suspension arm, enter the distance from the suspension arm’s inner pin to the outer bearing surface of the hub carrier as the suspension arm length, and set the scrub amount to zero.
● Hub carrier offset = Distance between the hub carrier pin and the outer bearing surface of the hub carrier (3.5 mm for YD-2 standard)
*If it is difficult to measure the hub carrier scrub amount, with the hub carrier mounted on the suspension arm, enter the distance from the suspension arm’s inner pin to the outer bearing surface of the hub carrier as the suspension arm length, and set the scrub amount to zero.
| Full width | mm |
*Please consider the calculation results as a reference only. Wheel hub/wheel offset may vary slightly depending on the model. The offset values listed here are based on Yokomo wheels. Camber and toe angles are not taken into account.
No customer feedback for this calculation yet.