Calculation of Shell and Pipe Wall Thickness Based on Internal Pressure in Pressure Vessels—Pressure Vessels
Author: morimoritarouExecutions: 1930
※ This library was created by a member. This site is not responsible for its content.
Manufactured for a Type II Pressure Vessel application
| Calculated value = | |
| t = minimum thickness of the plate | mm (*3) |
| [Remaining Safety Margin] | mm[Evaluation] |
*1 The minimum efficiency for longitudinal joints is
1.0 for TP-S seamless pipes.
*2 The allowable tensile stress of the material is
P59 B 8267:2015, Annex B (Provisions): Allowable Tensile Stress of Standard Materials—please refer to this.
Calculation of Allowable Tensile Stress Using the Interpolation Method
https://keisan.site/exec/user/1722577940
*3 Per instructions from the Japan Boiler Association,
calculate to the fourth decimal place and round off
1.0 for TP-S seamless pipes.
*2 The allowable tensile stress of the material is
P59 B 8267:2015, Annex B (Provisions): Allowable Tensile Stress of Standard Materials—please refer to this.
Calculation of Allowable Tensile Stress Using the Interpolation Method
https://keisan.site/exec/user/1722577940
*3 Per instructions from the Japan Boiler Association,
calculate to the fourth decimal place and round off
No customer feedback for this calculation yet.